Installing smoothing rollers
Caution:
Observe the safety directives in the ‘Replacing the smoothing rollers — overview’ on page
454 section.
Attention:
Observe the smoothing roller combination
It is recommended that you install the hard smoothing roller (gray surface, order number
S29312-F1430) in the upper print unit and the soft smoothing roller (red surface, order
number S29312-F1431) in the lower print unit.
To install the smoothing rollers
#
Proceed as follows:
If the lower smoothing roller is to be replaced: continue with step 2.
If only the upper smoothing roller is to be replaced: continue with step 7.
1.
Caution
Do not damage the smoothing roller
Ensure that you do not damage the smoothing rollers on the edges of the
blower unit.
Chapter 9 - Replacing Expendables 461
Installing smoothing rollers
To Next Page
Loading...
