Operation
Introduction
Observe the following instructions when operating the printing system:
Service personnel
Only operators, key operators and Service personnel may operate the printing system.
The printing system must not be operated by persons under the influence of alcohol or
drugs, or by persons taking certain types of medication, such as psychotropic drugs.
Before operating the printing system, carefully read through the documentation. Please
ask if you do not understand anything in the documentation (e. g. regarding Service).
In cases of emergency, power off the printing system off immediately with the main
switch. In the event of damage to the casing, power cable or operating elements, or pen-
etration of fluids or foreign bodies, call the appropriate Service representative.
Do not wear any loose hanging clothing (e. g. ties, sleeves, scarves), necklaces and bracelets,
loose belts, rings and unprotected long hair. These can catch in the drive mechanisms or
moving parts of the printing system and cause injury.
Safety covers
Do not attempt to remove safety covers yourself; do not manipulate safety equipment
such as the switches monitoring the safety covers, fuses etc., and do not perform any work
not intended to be performed by operators. Such action can cause accidents and may also
damage the printing system.
Safe operation of the printing system is guaranteed only when the outer paneling is fully
mounted. Only properly and fully affixed casing ensures:
■
Protection from electrical shocks
■
Protection against injury from mechanical parts, e.g. cuts, drawing in, crushing
■
Protection against the spread of fire
■
Sufficient cooling of the printing system.
Keep all doors, trims, flaps and covers closed while the printing system is in operation.
This ensures that limit values for electromagnetic compatibility are not exceeded. Noise
emission is also minimized.
Chapter 2 - Safety 39
Operation
To Next Page
Loading...
