Oce ColorStream - Fill in Developer

Fill in Developer
Caution:
Observe the safety directives in the ‘Replacing the Developer - Overview’ on page 336 section.
Attention:
Ensure that there is enough toner in the developer station.
In order to achieve the necessary mixture, there must always be sufficient toner in the
developer station before the developer can be filled.
To Fill the Developer
#
Proceed as follows:
If the developer is not filled immediately after draining:
On the operator panel, select the following menus and elements:
■
'Replace consumables' -> 'Replace developer' menu
■
'Select print unit': 'Upper print unit' or 'Lower print unit'
■
'Select developer station': 'Station 1:' to 'Station 5:'
■
'Select action': 'Refill developer'
■
Click the 'Next' button.
1.
Click the 'OK' button to start the process.
Caution
Wait until preparation is complete:
The doors must not be opened before the relevant message is displayed on the
operator panel.
Chapter 8 - Replacing Consumables340
Fill in Developer