Oce ColorStream - Page 248

Proceed as follows:
Note
Before the color calibration is started, the current settings are automatically
stored in a "calibration setup". When the color calibration is cancelled, this
configuration is then restored.
The following additional steps are required for manual scanning of the print-
outs:
■
Click the 'Next' button.
■
Cut at least three test print job sets from the printed paper web. (see ‘Re-
moving the paper web ’ on page 155).
■
From each printed set, cut the page with the printed 'Identification number'
on a suitable surface to the appropriate paper size.
■
‘Scanning Test Pages for Color Calibration’ on page 249 all entries in the list.
If the correction data is determined automatically, you can go directly to 'Step
3: Evaluate' (see ‘Analyzing Test Pages for Color Calibration’ on page 253).
6.
‘Scanning Test Pages for Color Calibration’ on page 249 all entries in the list.7.
Chapter 6 - Operating the Printing System248
Printing Test Pages for Color Calibration