Caution
Observe the safety directives
When replacing the individual expendables, observe the safety directives in the
relevant sections of the documentation.
Replace the relevant expendables one after the other. For more detailed infor-
mation on replacing the individual expendables, see:
■
‘Replacing the developer station — overview’ on page 165
■
‘Replacing the Belt — Overview’ on page 350 (photoconductor belt, photo-
conductor blade, transfer belt)
■
‘Replacing the corotron — overview’ on page 412
■
‘Replacing the cleaning brush — overview’ on page 433
■
‘Replacing fine filter’ on page 443
5.
#
Proceed as follows:
In the 'Consumables' table, highlight all expendables that were replaced in expert
mode by clicking on these items.
6.
Note
All replaced belts must be run in; they cannot be removed from the selection.
Optionally, belts that have been removed for inspection and refitted can be run
in.
Under 'Select belts to be run in:', highlight all photoconductor and transfer
belts that are to be run in one after the other.
7.
Chapter 9 - Replacing Expendables470
Replacing Expendables in Expert Mode
To Next Page
Loading...
