Proceed as follows:
Ensure that:
■
All belts have been inserted to the point where the correct belt position is
confirmed and have been tensioned
■
The toner mark sensors and the reload corotron have been swiveled on
■
All locking flaps have been closed
■
All developer stations have been pushed in.
8.
#
Close all printing system doors:
■
‘Closing Left Doors’ on page 163.
■
‘Closing Right Doors’ on page 159.
9.
#
Proceed as follows:
To end the replacement of expendables in expert mode, click the 'Exit' button.
This means:
■
The developer stations are swiveled on again
■
The selected belts are run in one after the other
■
The counters for all expendables that were highlighted in the table are reset
■
A summary of the replaced expendables and the belts that have been run in
is displayed.
10.
Complete the replacement in expert mode on the operator panel:
■
To carry out further maintenance work directly afterwards, click the 'OK'
button.
The printing system remains in the 'Special functions' status.
■
To complete all maintenance work, click the 'Ready' button.
All printing system assemblies are checked (duration around two minutes),
before the printing system is switched to the 'Stop' status.
To switch the printing system to the 'Ready' status, click the 'Ready' button
again.
11.
Chapter 9 - Replacing Expendables 471
Replacing Expendables in Expert Mode
To Next Page
Loading...
