Proceed as follows:
Swivel locking flaps down
against the stop point.
Then close the handles.
4.
If installing the cleaning brush in the upper print unit:
Close all doors on the right-hand side of the printing system.
5.
If installing the cleaning brush in the lower print unit:
Close all doors on the left-hand side of the printing system.
Indicate on the operator panel whether a new cleaning brush was installed:
■
When you click the 'Yes' button:
The message on the operator panel is deleted automatically, the replacement
of the cleaning brush is recorded in the 'Consumable history' menu and
the consumable counter is reset.
■
When you click the 'No' button:
The consumable counter is not reset.
6.
Complete the brush replacement on the operator panel:
■
To carry out further maintenance work directly afterwards, click the 'OK'
button.
The printing system remains in the 'Special functions' status.
■
To complete all maintenance work, click the 'Ready' button.
All printing system assemblies are checked (duration around two minutes),
before the printing system is switched to the 'Stop' status.
To switch the printing system to the 'Ready' status, click the 'Ready' button
again.
7.
Chapter 9 - Replacing Expendables438
Installing the cleaning brush of the photoconductor unit
To Next Page
Loading...
