Oce ColorStream - Page 295

Proceed as follows:
Close the paper output flap.18.
If the sensors have detected paper web residue in the printing system, respond
to the additional query on the operator panel:
■
If absolutely all paper web residue has been removed from the paper input,
the print unit, paper cooling and paper output, click the 'Yes' button.
■
If you were unable to remove all paper web residue or there is still paper
residue in the fuser station, click the 'No' button and notify Service.
19.
Close all printing system doors.
■
‘Closing Left Doors’ on page 163.
■
‘Closing Right Doors’ on page 159.
20.
Complete the cleaning of the paper path on the operator panel:
■
To carry out further maintenance work directly afterwards, click the 'OK'
button.
The printing system remains in the 'Special functions' status.
■
To complete all maintenance work, click the 'Ready' button.
All printing system assemblies are checked (duration around two minutes),
before the printing system is switched to the 'Stop' status.
To switch the printing system to the 'Ready' status, click the 'Ready' button
again.
21.
Chapter 7 - Cleaning the Printing System 295
Cleaning the Paper Path