Proceed as follows:
Indicate on the operator panel whether a new cleaning brush was installed:
■
When you click the 'Yes' button:
The message on the operator panel is deleted automatically, the replacement
of the cleaning brush is recorded in the 'Consumable history' menu and
the consumable counter is reset.
■
When you click the 'No' button:
The consumable counter is not reset.
5.
Complete the brush replacement on the operator panel:
■
To carry out further maintenance work directly afterwards, click the 'OK'
button.
The printing system remains in the 'Special functions' status.
■
To complete all maintenance work, click the 'Ready' button.
All printing system assemblies are checked (duration around two minutes),
before the printing system is switched to the 'Stop' status.
To switch the printing system to the 'Ready' status, click the 'Ready' button
again.
6.
Chapter 9 - Replacing Expendables442
Installing the cleaning brush of the transfer unit.
To Next Page
Loading...
