Attention:
Avoid incidence of light
All 10 slots must be occupied either with developer stations or light protection covers. If
a developer station is removed and stored without being replaced by another developer
station, a light protection cover must be fitted in this slot. If you wish to re-install a de-
veloper station, you must first remove the light protection cover.
Attention:
Avoid damage
Bear in mind the width and height of the replacement cart when moving it.
Note:
An additional adapter to hold developer stations allows developer stations to be stored
complete with adapter. Rearranging the individual developer stations within the adapter
is thus no longer necessary.
The procedure for changing a developer station is the same for all colors and both print
units.
Maintenance Cart
The maintenance cart consists of the following components:
Chapter 6 - Operating the Printing System166
Replacing the developer station — overview
To Next Page
Loading...
