Proceed as follows:
If necessary, adjust the color separation shift of the colors to an optimal level
in relation to one another:
■
On the operator panel, select the 'Configuration' -> 'Color' -> 'Color plane
shift' menu.
■
Enter correction values for each color on the 'Upper print unit' or 'Lower
print unit' tab.
Notes:
■
The settings for the register apply to the color print sequence; they are not
linked to a particular color. If the color sequence is changed in the 'Color
sequence' menu, the values already set for the register will remain un-
changed.
■
Register values can be set using the control slider or by entering numerical
values (in increments of 14 mpt).
The permitted threshold values are displayed. The unit of measurement
can be selected from the list. Rounding is accurate to the mpt.
■
All color separation shifts in the upper or lower print unit can be reset to
the default setting of "0" using the 'Set to 0' button.
4.
If the paper web has been removed from the printing system: ‘Affixing the paper
web’ on page 152.
5.
Chapter 6 - Operating the Printing System256
Correcting Color Separation Shifts
To Next Page
Loading...
