Oce ColorStream - Page 371

Proceed as follows:
On the left-hand side of the
printing system:
Slip the green tube with the
photoconductor belt onto the
photoconductor unit at the point
marked in green, then pull the
photoconductor belt forwards to
the edge of the tube.
3.
Slip the red tube onto the photo-
conductor unit at the lower red
point.
4.
Take the empty red tube out of
the packaging and slip it onto
the photoconductor unit at the
second red point.
5.
Chapter 9 - Replacing Expendables 371
Inserting a Photoconductor Belt in the Lower Print Unit