Oce ColorStream - Page 394

Proceed as follows:
On the operator panel, enter whether a new transfer belt was inserted:
■
When you click the 'Yes' button:
The message on the operator panel is deleted automatically, the replacement
of the transfer belt is recorded in the 'Consumable history' menu and the
consumable counter is reset.
■
When you click the 'No' button:
The consumable counter is not reset.
7.
#
On the operator panel, enter whether the transfer belt is to be run in:
■
When you click the 'Yes' button:
The printing system remains in the 'Special functions' status. The belt can
be run in immediately afterwards (see ‘Running in a Belt’ on page 411).
■
When you click the 'No' button:
All printing system assemblies are checked (duration around two minutes),
before the printing system is switched to the 'Stop' status.
To switch the printing system to the 'Ready' status, click the 'Ready' button
again.
8.
Chapter 9 - Replacing Expendables394
Insertion of a Transfer Belt in the Upper Print Unit (Completion)