Proceed as follows:
When installing a corotron slide-in unit in the lower print unit:
Close all doors on the left-hand side of the printing system.
4.
On the operator panel, enter whether a new corotron was installed:
■
When you click the 'Yes' button:
The message on the operator panel is deleted automatically, the replacement
of the corotron is recorded in the 'Consumable history' menu and the
consumable counter is reset.
■
When you click the 'No' button:
The consumable counter is not reset.
5.
Complete the corotron replacement on the operator panel:
■
To carry out further maintenance work directly afterwards, click the 'OK'
button.
The printing system remains in the 'Special functions' status.
■
To complete all maintenance work, click the 'Ready' button.
All printing system assemblies are checked (duration around two minutes),
before the printing system is switched to the 'Stop' status.
To switch the printing system to the 'Ready' status, click the 'Ready' button
again.
6.
Chapter 9 - Replacing Expendables 417
Installing the cleaning corotron slide-in unit or charge corotron slide-in unit of the photoconductor unit
To Next Page
Loading...
