The [Input] field represents the input density (%) of the selected anchor point on the curve.
The [Output] field represents the output density (%) of the selected anchor point on the
curve.
• Use the + and - buttons of the [Input] and [Output] fields to change the position of an
anchor point .
• Drag an anchor point to another position. A raster can help to locate the anchor point.
11. Contrast
• Plot also anchor points on the [C] and [Y] curves.
• Press .
• Touch the contrast slider to adjust the contrast.
• Touch [Reset] to restore the original CMYK job curves.
12. Clip the highlight and shadow tones.
Explore the pixel-precise preview
184
Chapter 8 - Document printing
To Next Page
Loading...
