Parker AC30 series User Manual

12-12 Ethernet
AC30V series Variable Speed Drive
Parameter Summary
PNO Parameter Descriptions
0919
Ethernet State
Type: USINT (enumerated)
Base Communications parameter.
Provides the state of the AC30 Ethernet link.
Range: RW/RO Saved Config
(0) INITIALISING - Driver initialising
(1) NO LINK - Ethernet not connected to a network
(2) RESOLVING IP - Waiting for an IP address to be set manually
(3) RESOLVING DHCP - Waiting for a DHCP server to provide an IP address
(4) RESOLVING AUTO-IP - Waiting to Auto-IP to provide an IP address
(5) RESOLVED IP - IP address is set – communication is possible
(6) STOPPING DHCP - AC30 is stopping the DHCP service
(7) DUPLICATE IP - Another device on the network has the same IP address
(8) FAULT
- Fault detected
RO
 
0920
MAC Address
Type: String
Base Communications parameter.
Provides the state of the AC30 Ethernet link.
Range: RW/RO Saved Config
xx-xx-xx-xx-xx-xx RO
 
www.comoso.com

Parker AC30 series Specifications

General

Control Modes	Closed-loop vector
Feedback	Encoder
Operating Temperature	0 to 40°C (32 to 104°F) standard, -20 to 50°C (-4 to 122°F) with derating
Protection	Overcurrent, Overvoltage, Undervoltage
Communication	RS485