Compliance C-2
AC30V series Variable Speed Drive
EUROPEAN COMPLIANCE
CE MARKING
The CE marking is placed upon the product by Parker Hannifin Manufacturing Ltd to facilitate its free movement within
the European Economic Area (EEA). The CE marking provides a presumption of conformity to all applicable directives.
Harmonized standards are used to demonstrate compliance with the essential requirements laid down in those relevant
directives.
It must be remembered that there is no guarantee that combinations of compliant components will result in a compliant
system. This means that compliance to harmonised standards will have to be demonstrated for the system as a whole
to ensure compliance with the directive.
Low Voltage Directive
When installed in accordance with this manual the product will comply with the low voltage directive 2006/95/EC.
Protective Earth (PE) Connections
Only one protective earth conductor is permitted at each protective earth terminal contacting point.
The product requires a protective earth conductor cross section of at least 10mm², where this is not possible a second
protective earth terminal provided on the VSD (Variable Speed Drive) shall be used. The second conductor should be
independent but electrically in parallel.
EMC Directive
When installed in accordance with this manual the product will comply with the electromagnet compatibility directive
2004/108/EC.
The following information is provided to maximise the Electro Magnetic Compatibility (EMC) of VSDs and systems in
their intended operating environment, by minimising their emissions and maximising their immunity.
Local wiring regulations always take precedence.
Where there are any conflicts between regulatory standards for example earthing requirements for
electromagnetic compatibility, safety shall always take precedence.
To Next Page
Loading...
Need help?
General
