Parameter Reference D-67
AC30V series Variable Speed Drive
Motor Sequencer
Parameters::Motor Control::Motor Sequencer
These parameters are associated to the internal motor sequencer states machine to start and stop the motor control.
PNO Parameter Descriptions
1560
Start Delay Enable
Enable the delay to action “ramping to Setpoint” from the Run Command. This can allow a period for motor flux to establish ( AC
induction motor ) before the ramp to setpoint
1634
Start Delay
Time to delay the action of “ramping to Setpoint” from the Run Command in seconds.
1635
Delay to Start
Remaining time of the delay before “ ramping to Setpoint” after the Run Command occurs.
To Next Page
Loading...
