D-2 Parameter Reference
AC30V series Variable Speed Drive
App Info
Parameters::Application::App Info
Details of the Application loaded in the Drive. An Application is built as part of a project using a suitable programming tool. When downloaded into
the Drive an Application within the Project can be selected to run. Some Projects only contain a single Application, so in this case will always be
selected.
PNO Parameter Descriptions
1040 Project File Name
The name of the file on the programming PC used to store the application. (This does not include the .project or .projectarchive file
name extension.)
1047 Last Modification
Timestamp of when the loaded Project was last modified. (Note - the RTC option is not required for this.)
1048 IDE Version
The version of programming tool (Interactive Development Environment) used to create the loaded Project.
1054 Project Author
The Author of the loaded Project as entered in the programming tool when it was created.
1061 Project Version
The Project version of the loaded Project as entered by the programmer when creating the Project.
1068 Project Description
A description of up to 80 characters entered by the programmer when creating the Project.
1554 Application Name
The name of the selected Application within the loaded Project.
To Next Page
Loading...
