Parker AC30 series User Manual

Parameter Reference D-1
AC30V series Variable Speed Drive
Appendix D: Parameter Reference
Parameter Descriptions
The parameter descriptions in this section are arranged alphabetically; however, they are also listed below by Category. Expert view level must
be selected to see all the parameters listed under the Parameters menu.
Page
Page
Page
Motor Control
Auto Restart
D-3
Spd Loop Settings
D-108
Modbus TCP Option
D-62
Autotune
D-6
Speed Ref
D-111
Profibus DP-V1 Option
D-85
Braking
D-12
Stabilisation
D-112
Profinet IO Option
D-86
Control Mode
D-19
Stack Inv Time
D-113
Trips
Current Limit
D-22
Torque Limit
D-116
Trips Status
D-121
Current Loop
D-23
Tr Adaptation
D-119
Trips History
D-120
DC Link Volts Limit
D-25
Voltage Control
D-123
Stall Trip
D-115
Energy Meter
D-32
Inputs And Outputs
VDC Ripple
D-122
Feedbacks
D-36
IO Configure
D-52
Current Sensor Trip
D-24
Filter On Torque Dmd
D-38
IO Values
D-56
Keypad
Fluxing VHz
D-40
Option IO
Graphical Keypad
D-48
Flycatching
D-44
IO Option Common
D-55
Local Control
D-58
Induction Motor Data
D-50
General Purpose IO
D-46
Application
Inj Braking
D-51
Encoder
D-31
App Info
D-2
Motor Load
D-63
Thermistor
D-118
Skip Frequencies
D-100
Motor Nameplate
D-66
Base Comms
Minimum Speed
D-59
Motor Sequencer
D-67
Ethernet
D-34
Preset Speeds
D-83
Pattern Generator
D-68
Modbus
D-60
Raise Lower
D-87
PMAC Flycatching
D-71
Web Server
D-124
PID
D-69
PMAC Motor Data
D-72
Option Comms
Device Manager
PMAC SVC
D-74
Communications Options
D-18
Clone
D-14
Power Loss Ride Thru
D-81
BACnet IP Option
D-10
Device State
Ramp
D-89
BACnet MSTP Option
D-11
Device Commands
D-27
Scale Setpoint
D-95
CANopen Option
D-13
Drive info
D-29
Sequencing
D-97
ControlNet Option
D-21
Real Time Clock
D-93
Slew Rate
D-103
DeviceNet Option
D-28
Runtime Statistics
D-94
Slip Compensation
D-104
EtherCAT Option
D-33
Setup Wizard
D-99
Spd Direct Input
D-106
EtherNet IP Option
D-35
SD Card
D-96
Spd Loop Diagnosis
D-107
Modbus RTU Option
D-61
Soft Menus
D-105
For details about parameter limits and other attributes refer to the Parameter Table at the end of this appendix. The Parameter Number, (PNO),
provided next to each parameter description may be used to quickly find an entry in the Parameter Table at the end of this Appendix by clicking
on the link.
www.comoso.com

Parker AC30 series Specifications

General

Control Modes	Closed-loop vector
Feedback	Encoder
Operating Temperature	0 to 40°C (32 to 104°F) standard, -20 to 50°C (-4 to 122°F) with derating
Protection	Overcurrent, Overvoltage, Undervoltage
Communication	RS485