Appendix A: Maintenance
347
Be sure you install the battery with the writing side up.
2. Place the motherboard back into the enclosure.
Carefully align the PCI slot with the daughterboard and gently press the two
boards together.
3. Install the four screws that hold the motherboard in place.
4. Attach the three-wire fan power connector at the motherboard.
5. Place the back cover in position and install the four screws.
6. Plug in the motherboard power connector.
7. Lay the cover in position and press it down until the two latches snap shut.
8. Lay the side cover in position and slide is backward all the way.
9. Install the side cover locking screw and set the SmartStor on its feet.
10. Plug in the power cord.
11. Boot the SmartStor.
See “Connecting the Power” on page 10.
To Next Page
Loading...
