SmartStor NS4600 Product Manual
340
Connection Problems After Restart
If your SmartStor’s network settings were set to Obtain an IP address
automatically, your DHCP server might assign a different IP address to the
SmartStor when you restart the SmartStor after is was shutdown for repairs.
This condition does not apply if you assigned your SmartStor’s IP address
manually.
If you experience network drive or printer connection failures, check the
SmartStor’s current IP address. See “Finding the SmartStor’s IP Address” on
page 23.
If the SmartStor’s IP address has changed, your previous network drives and
printer connections will no longer work.
Here are two possible solutions:
• You may be able to reset the SmartStor’s IP address manually. See
“Changing Network Settings” on page 137 or “Making Network Settings” on
page 252.
Note that changing the SmartStor’s IP address may cause an IP address
conflict on your network. Check with your Network Administrator before
taking this action.
• If you cannot restore the previous IP address, you must create new network
drives and printer connections. See “Chapter 3: Connecting to the
SmartStor” on page 31.
Replacing the Power Supply
The SmartStor NS4600 uses the following power supply.
• Make and model: Edac EA11003E
• Input: 100 to 240 V, 2.5 A , 50-60 Hz
• Output: 12V, 8.33A max. through a DIN 22, 4-pin connector
Removing the Power Supply
To remove the old power supply:
1. Shut down the SmartStor.
See “Shutting Down the SmartStor” on page 30 or page 271.
Important
If your SmartStor is still under warranty, contact Technical Support
for repair under RMA. See page 329.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
