Quanta Computer T5016-LB8D - Page 192

UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
_____________________________________________________________________________
LB9 User’s Guide 192/1523
6.3.1.4 interface vlan
This command is used to create a vlan interface and enter Interface-vlan configuration mode.
Syntax
interface vlan <vlan-id>
<vlan-id> - VLAN ID (Range: 1 - 4093).
Default Setting
None
Command Mode
Global Config
6.3.1.5 ip address
This command sets the IP Address, and subnet mask. The IP Address and the gateway must be on the
same subnet.
Syntax
ip address <ipaddr> <netmask>
no ip address
<ipaddr> - IP address
<netmask> - Subnet Mask
no - Restore the default IP address and Subnet Mask
Default Setting
IP address: 0.0.0.0
Subnet Mask: 0.0.0.0
Command Mode
Interface-Vlan Config
Command Usage
Once the IP address is set, the VLAN ID’s value will be assigned to management VLAN.