_____________________________________________________________________________
LB9 User’s Guide 335/1523
URL Redirect Mode: Indicates whether the Redirect URL Mode is enabled or disabled.
Max Bandwidth Up(bytes/sec): The maximum rate in bytes per second (bps) at which a client can
send data into the network.
Max Bandwidth Down (bytes/sec): The maximum rate in bps at which a client can receive data
from the network.
Max Input Octets (bytes): The maximum number of octets the user is allowed to transmit.
Max Output Octets (bytes): The maximum number of octets the user is allowed to receive.
Max Total Octets (bytes): The maximum number of octets the user is allowed to transfer, i.e., the
sum of octets transmitted and received.
Session Timeout (seconds): Shows the number of seconds a user is permitted to remain
connected to the network. Once the Session Timeout value is reached, the user is logged out
automatically. A value of 0 means that the user does not have a session Timeout limit.
Idle Timeout(seconds): Shows the number of seconds the user can remain idle before the switch
automatically logs the user out. A value of 0 means that the user will not be logged out automatically.
6.8.1.21 show captive-portal interface [slot/port] client status
This command displays information about clients authenticated on all interfaces or a specific interface.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Interface: Valid slot and port number separated by a forward slash.
Interface Description: Describes the interface.
Client MAC Address: Identifies the MAC address of the wireless client (if applicable).
If you use the optional [slot/port] information, the following additional information appears:
Client IP Address: Identifies the IP address of the wireless client (if applicable).
CP ID: Shows the captive portal ID the connected client is using.
CP Name: Shows the name of the captive portal the connected client is using.
Protocol: Shows the current connection protocol, which is either HTTP or HTTPS.
Verification: Shows the current account type, which is Guest, Local, or RADIUS.
User Name: Displays the user name (or Guest ID) of the connected client.
To Next Page
Loading...
Need help?
General