R&S ESR Series User Manual

I/Q Analyzer
R&S
®
ESR
465User Manual 1175.7068.02 ─ 12
Y-Axis Max
Opens an edit dialog box to specify the maximum value of the y-axis in either direction
(in Volts). Thus, the y-axis scale starts at -<Y-AxisMax> and ends at +<Y-AxisMax>.
This command is only available if the display configuration for the I/Q Analyzer is set to
"I/Q Vector" or "Real/Imag (I/Q)", see "Display Config" on page 460.
Range
Opens a submenu to define the display range of the level axis.
●
Range Log 100 dB
●
Range Log 50 dB
●
Range Log 10 dB
●
Range Log 5 dB
●
Range Log 1 dB
●
Range Log Manual
●
Range Linear %
●
Range Lin. Unit
Range Log 100 dB ← Range
Sets the level display range to 100 dB.
Remote command:
Logarithmic scaling:
DISP:WIND:TRAC:Y:SPAC LOG, see DISPlay[:WINDow<n>]:TRACe<t>:Y:
SPACing on page 668
Display range:
DISP:WIND:TRAC:Y 100DB, see DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]
on page 844
Range Log 50 dB ← Range
Sets the level display range to 50 dB.
Remote command:
Logarithmic scaling:
DISP:WIND:TRAC:Y:SPAC LOG, see DISPlay[:WINDow<n>]:TRACe<t>:Y:
SPACing on page 668
Display range:
DISP:WIND:TRAC:Y 50DB, see DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]
on page 844
Range Log 10 dB ← Range
Sets the level display range to 10 dB.
Remote command:
Logarithmic scaling:
DISP:WIND:TRAC:Y:SPAC LOG, see DISPlay[:WINDow<n>]:TRACe<t>:Y:
SPACing on page 668
Display range:
DISP:WIND:TRAC:Y 10DB, see DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]
on page 844
Softkeys of the Amplitude Menu in I/Q Analyzer Mode

R&S ESR Series Specifications

General

Brand	R&S
Model	ESR Series
Category	Receiver
Language	English