R&S ESR Series

Remote Control
R&S
®
ESR
680User Manual 1175.7068.02 ─ 12
CALCulate<n>:PEAKsearch|PSEarch[:IMMediate]
This command initiates a peak search and creates a peak list.
Example:
CALC:PEAK
Initiates a peak search.
Usage: Event
CALCulate<n>:PEAKsearch|PSEarch:MARGin <Margin>
This command defines a margin for the peak search.
Suffix:
<n>
.
irrelevant
Parameters:
<Margin> Range: -200 dB to 200 dB
*RST: 6 dB
Example:
CALC:PEAK:MARG 5 dB
Manual operation: See "Margin" on page 193
See "Margin" on page 264
See "Margin" on page 293
CALCulate<n>:PEAKsearch|PSEarch:METHod <Method>
This command selects the way the R&S ESR creates a peak list.
Suffix:
<n>
.
irrelevant
Parameters:
<Method> SUBRange
Divides the scan range into smaller subranges and looks for a
particular number of peaks in each subrange.
PEAK
Looks for a particular number of peaks over the complete scan
range.
*RST: PEAK
Example:
CALC:PEAK:METH SUBR
Divides the scan range into smaller subranges for the peak
search.
Manual operation: See "Peak Search Mode (Peaks Subranges)" on page 192
CALCulate<n>:PEAKsearch|PSEarch:SUBRanges <Peaks> | <Subranges>
The effects of this command depend on the peak search mode that you have selected.
Remote Commands in Receiver Mode