R&S ESR Series User Manual

Remote Control
R&S
®
ESR
849User Manual 1175.7068.02 ─ 12
Parameters:
<State> ON | OFF
*RST: OFF
Example:
CALC:MATH:STAT ON
Switches on the trace mathematics.
Manual operation: See "Trace Math" on page 394
See "Trace Math Off" on page 395
DISPlay[:WINDow<n>]:TRACe<t>:MODE:HCONtinuous <State>
This command defines whether traces in Min Hold, Max Hold and Average mode (see
DISPlay[:WINDow<n>]:TRACe<t>:MODE on page 683) are reset after a parameter
is changed.
Normally, the measurement is started anew after parameter changes, before the mea-
surement results are evaluated (e.g. using a marker). In all cases that require a new
measurement after parameter changes, the trace is reset automatically to avoid false
results (e.g. with span changes). For applications that require no reset after parameter
changes, the automatic reset can be switched off.
Suffix:
<n>
.
window; For applications that do not have more than 1 measure-
ment window, the suffix <n> is irrelevant.
<t> trace
Parameters:
<State> ON
The automatic reset is switched off.
OFF
After certain parameter changes the traces are reset.
*RST: OFF
Example: DISP:WIND:TRAC3:MODE:HCON ON
Switches off the reset function.
Manual operation: See "Hold/Cont" on page 391
DISPlay[:WINDow<n>]:TRACe<t>[:STATe] <State>
This command switches on or off the display of the corresponding trace. The other
measurements are not aborted but continue running in the background.
Suffix:
<n>
.
window; For applications that do not have more than 1 measure-
ment window, the suffix <n> is irrelevant.
<t> trace
Remote Commands in Spectrum Analyzer Mode

R&S ESR Series Specifications

General

Brand	R&S
Model	ESR Series
Category	Receiver
Language	English