R&S ESR Series

Remote Control
R&S
®
ESR
964User Manual 1175.7068.02 ─ 12
Example:
HCOP:DEV:LANG BMP
Selects the data format.
HCOP:DEST 'MMEM'
Directs the hardcopy to a file.
MMEM:NAME 'C:\R_S\instr\user\Print.bmp'
Selects the file name. If the file Print.bmp already exists, it is
replaced.
HCOP
Saves the hardcopy output into the file Print.bmp.
Example:
HCOP:MODE REPort
HCOP:DEV:LANG PDF
HCOP:TREP:NEW
HCOP
Creates a measurement report (in pdf format).
Usage: Event
SCPI confirmed
Manual operation: See "ScreenShot" on page 533
See "Print Screen" on page 543
See "Configuring and Printing the Test Report" on page 550
HCOPy[:IMMediate<1|2>]:NEXT
This command initiates a print job.
If you are printing to a file, the file name depends on MMEMory:NAME. This command
adds a consecutive number to the file name.
The suffix <1|2> selects the printing device.
Example:
HCOP:DEV:LANG BMP
Selects the data format.
HCOP:DEST 'MMEM'
Directs the hardcopy to a file.
MMEM:NAME 'C:\R_S\instr\user\Print.bmp'
Selects the file name.
HCOP
Saves the hardcopy output into the file Print.bmp.
HCOP:NEXT
Saves the hardcopy output into the file Print_001.bmp.
HCOP:NEXT
Saves the hardcopy output into the file Print_002.bmp.
Usage:
Event
SCPI confirmed
Manual operation: See "Print Screen" on page 543
Documentation