R&S ESR Series

Remote Control
R&S
®
ESR
980User Manual 1175.7068.02 ─ 12
Example:
DISP:PSAV:HOLD 30
Manual operation: See "Display Pwr Save (On/Off)" on page 523
DISPlay:PSAVe[:STATe] <State>
This command switches on or off the power-save mode of the display. With the power-
save mode activated the display including backlight is completely switched off after the
elapse of the response time (see DISPlay:PSAVe:HOLDoff command).
This mode is recommended to protect the display, especially if the instrument is oper-
ated exclusively via remote control.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
DISP:PSAVe ON
Switches on the power-save mode.
Manual operation: See "Display Pwr Save (On/Off)" on page 523
DISPlay:SBAR[:STATe] <State>
This command turns the status bar in the display on and off.
Parameters:
<State> ON | OFF
*RST: ON
Example:
DISP:SBAR OFF
Manual operation: See "Status Bar" on page 520
DISPlay:SKEYs[:STATe] <State>
This command turns the softkey bar in the display on and off.
Parameters:
<State> ON | OFF
*RST: ON
Example:
DISP:SKEY OFF
DISPlay:TBAR[STATe] <State>
This command turns the toolbar in the display on or off.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
DISP:TOOL ON
Display Configuration