Raymarine LIGHTHOUSE 3 - 4.4 Switching on and off at the breaker; 4.5 Getting started; First power up

P
oweringoffthedisplay
1.Pressthe Powerbutton.
2.FromtheShortcutspagepressandholdthepowericonforapproximately2seconds.
Alternativelyyoucanpressandholdthe
Powerbuttonforapproximately6secondstopoweroff
yourdisplay.
Note:
Whenpoweredoff ,theunitmaystilldrawasmallamountofpowerfromthebattery.Ifthisisa
concern,unplugthepowersupplyorswitchoffatthebreaker.
4.4S witchingonandoffatthebreaker
IfyouwishtoensurethattheMFDisnotconsuminganypowerthenitmustbeswitchedoffatthe
breakerorhavethepowercableunplugged.
Whenthebreakerisswitchedbackon,orthecableisreconnected,theMFDwillresumeinthesame
powerstatethatitwasinwhenitwasswitchedoff.
4.5Gettingstarted
Firstpowerup
WhenyoupowerupyournewMultifunctionDisplay(MFD)forthefirsttimeanumberofactions
arerequired.
ThelistbelowshowstheactionsthatshouldbeperformedonyournewMFD:
1.
Poweronthedisplay.
2.Selectyour
Datamaster(onlyrequiredonnetworkswithmorethan1MFD).
3.Completethe Startupwizard(thewizardwillnotbeshownifyouareconnectingtoanexisting
systemthathasalreadybeensetup).
4.Readandagreetothe LimitationsonUsedisclaimer.
5.Select/checkyourpreferred Datasources,ifrequired.
6.Perform Engineidentification,ifrequired.
7.Select/check Transducersettings,ifrequired
42