A.14
SEL-351A Relay Instruction Manual Date Code 20080213
Firmware and Manual Versions
Instruction Manual
Appendix D
➤ Updated A5C0 Relay Definition Block.
➤ Updated A5C1 Fast Meter Configuration Block.
➤ Updated A5D1 Fast Meter Data Block.
➤ Updated A5D2/A5D3 Demand/Peak Demand Fast Meter Message.
➤ Updated ID Message.
➤ Updated DNA Message.
Appendix E
➤ Updated CAS command response.
➤ Updated CEV command response.
Appendix G
➤ Updated Table G. 2 and Table G.3 to include the addition of new Relay Word bits to the SEL-351A.
Appendix H
➤ Added Extended Mode DNP Operation and Settings Sheet.
➤ Revised Table H.1 and Tabl e H.3 to reflect addition of extended mode and delta PT configuration features.
Appendix J
➤ New Appendix J: SEL-351A Fast SER Protocol.
➤ Old Appendix J becomes Appendix K.
This manual differs from the previous version as follows:
20010808
Section 1
➤ Add 220 V control input voltage option to General Specifications.
This manual differs from the previous version as follows:
20010525
Section 1
➤ Add Figure 2.5 reference.
➤ Updated Terminal Connections information.
Section 2
➤ Added vertical rear panel diagram to Figure 2.5.
➤ Added Forward to Tripping Direction label on Figure 2.6–Figure 2.13.
Section 8
➤ Add Figure 2.5 reference.
Section 9
➤ Corrected setting range for Voltage Elements (See Figure 3.22, Figure 3.23, Figure 3.24, Figure 3.25, and
Figure 3.26) on page SET.10.
This manual differs from the previous version as follows:
20010307
➤ Reissued entire manual.
➤ Added Caution, Danger, and Warning information to the back of the cover page of the Manual.
➤ Replaced Standard Product Warranty page with warranty statement on cover page.
Section 1
➤ Added Tightening Torque information to General Specifications.
➤ Updated Power Supply information to include medium range Power Supply Specification.
➤ Added optoisolated input ratings for ac control signals to General Specifications.
Section 2
➤ Updated Optoisolated Inputs on page 2.12 to include ac input selection.
➤ Added caution note to Clock Battery on page 2.38.
➤ Added Condition of Acceptability for North American Product Safety Compliance on page 2.37.
Table A.3 Instruction Manual Revision History (Sheet 8 of 10)
Revision
Date
Summary of Revisions
Courtesy of NationalSwitchgear.com
To Next Page
Loading...