Section05FUELSYSTEM
Subsection 02 (FUEL TANK AND FUEL PUMP)
Disconnect the wire connectorfrom the fuel pump
assembly.
Disconnect fuel vent hose from fuel pump assem-
bly.
Cover the quick connect fitting with a shop towel.
Press on both tabs and disconnect the quick con-
nect fitting.
WARNING
Fuel is under pressure. Wipe off any fuel
spillage in the bilge. Fuel is flammable and
explosive under certain conditions. Always
work in a well ventilated area.
Loosen nuts retaining the fuel pump assembly to
the fuel tank.
1
F07F0DB
TYPICAL
1. Loosen nuts
CAUTION: While pulling out the fuel pump, pay
attention to fuel sensor float arm. Float arm
can get stuck and bend which can reduce the
fuel sensor capabilities.
Remove fuel pump assembly from fuel tank.
WARNING
Always wipe off any fuel spillage from the wa-
tercraft. While dealing with fuel or fuel sys-
tem always work in well ventilated area.
Fuel Tank
The engine removal is necessary to remove fuel
tank on all models.
3D Series
Pull out both vent tubes.
F22J0AA
Remove ignition coils.
Disconnect fuel hoses. Refer to ENGINE MAN-
AGEMENT (RFI).
All Models
Siphon fuel tank.
Remove fuel baffle pick-up no. 7 (carburetor-
equipped models) or electric fuel pump (RFI
Models). Refer to the above section.
Detach all fuel tank straps no. 12.On3D Series,
to have access to the rear fuel tank holding strap,
remove exhaust hoses with the resonator.
F22D06A
1
1
1. Loosen clamps and pull out hoses with resonator
104 smr2005-053
To Next Page
Loading...
