Section 07 ELECTRICAL SYSTEM
Subsection 01 (IGNITION SYSTEM)
smr2005-057-013_a
1. Tool end
2. Flywheel mark
NOTE: This mark becomes the reference when
verifying the ignition timing (dynamic test).
– Remove TDC gauge.
– Reinstall spark plug and connect wire.
Verifying the Ignition Timing
(Dynamic Test)
To check ignition timing, use a timing light (avail-
able at local facilities).
NOTE: Ensure to use a timing light capable to
work with 2-stroke engines.
– Connect an induction-type tachometer (P/N 529
014 500) to spark plug wire.
F06H06A
1
1. Tachometer pick-up
– Connect timing light pick-up to MAG side spark
plug wire.
F00H0HA
1
1. Timing light pick-up
IMPORTANT: To properly check the ignition tim-
ing, the APS and WTS must be disconnected and
the timing tool installed so that timing advance
curvebelockedwithin800and6000RPManden-
gine fires on both cylinders at low speed.
– Disconnect APS (air pressure sensor).
smr2005-057 157
To Next Page
Loading...
