Section 07 ELECTRICAL SYSTEM
Subsection 04 (INSTRUMENTS AND ACCESSORIES)
Speedometer: Indicates the speed of watercraft
inkilometersperhour(KPH)ormilesperhour
(MPH).
Average Speed: The information center approxi-
mately calculates and displays the average speed
(AV KPH or AV MPH) of the watercraft since the
last engine start.
Trip Meter: The information center approximate-
ly calculates the distance based on the operation
time and the watercraft speed and displays the re-
sult in kilometers (KM) or miles (MILES).
Hour Meter: Displays the time in hours of the
watercraft usage.
Water Temperature: Displays the water temper-
ature of the water surface (L TEMP) in degrees
Celsius (°C) or Fahrenheit (°F).
Exterior Temperature: Displays the exterior air
temperature (E TEMP) in degrees Celsius (°C) or
Fahrenheit (°F).
Chronometer: Allows to measure an interval of
time in hours and minutes (hh:mm).
Message Display
The information center features a display area that
blinks a message whenever one of the following
circumstances occurs:
• compass error (COMPAS)
• maintenance (MAINT)
• engine overheating (H-TEMP)
• low fuel (FUEL-LO)
• low oil (OIL LOW)
• low voltage (12 V LOW).
A beeper will sound when one of the four last cir-
cumstances occurs.
Except for low fuel and low oil, which can be cor-
rected by refilling, it is recommended to see an au-
thorized SEA-DOO dealer when other messages
occur.
The warning light will blink at the same time.
Warning Light
The red warning LED (Light-Emitting Diode) blinks
along with the message display to catch your at-
tention.
Fuel Level Display
Bar gauge continuously indicates the amount of
fuel in the fuel tank while riding. A low-fuel con-
dition is also indicated when it occurs. See MES-
SAGE DISPLAY above.
Display Priorities
As a self test, all LCD segments and the LED
will turn on for 3 seconds each time the informa-
tion center is activated (when safety lanyard is in-
stalled).
When the information center is activated, the
last function set will be displayed if it was the
tachometer, speedometer or chronometer. If
another function was set, the compass will be
displayed. On models without the compass
function, the word “Sea Doo” will be displayed.
In the event of a warning message, the message
will blink and override the units display.
If more than one warning message occurs, the
blinking messages will scroll every 4 seconds.
Other Functions
The following describes how to select other avail-
able functions.
Language Option
While in the compass mode (while “SeaDoo” is
displayed on models without compass):
F00L2BC
1
1. Press and hold for 2 seconds
F00L2BB
1
1. Repeatedly press
smr2005-060 199
To Next Page
Loading...
Need help?
General
