Section07ELECTRICALSYSTEM
Subsection 04 (INSTRUMENTS AND ACCESSORIES)
The resistance measured between PINK/BLACK
and PINK wires of the sender must be in accor-
dance with fuel level (measured from under the
flange) as specified in the following chart.
FUEL LEVEL AND RESISTANCE
FUEL LEVEL (mm) RESISTANCE ( )
From 248.9 ± 5 and more 0+2.2
From 234.4 to 248.8 ± 5 17.8 ± 2.2
From 200.9 to 234.3 ± 5 27.8 ± 2.2
From 167.4 to 200.8 ± 5 37.8 ± 2.2
From 134.0 to 167.3 ± 5 47.8 ± 2.2
From 100.5 to 133.9 ± 5 57.8 ± 2.2
From 67.0 to 100.4 ± 5 67.8 ± 2.2
From 40.1 to 66.9 ± 5 77.8 ± 2.2
From 0 to 40.0 ± 5 89.8 ± 2.2
If out of specification, replace fuel sender. If
gauge does not work, check wiring/connectors.
If good, try a new gauge. If it still does not work,
tryanewMPEM.
RFI Models
The fuel level sender is part of the fuel pump mod-
ule mounted inside the fuel reservoir.
F07F09A
TYPICAL — FUEL LEVEL GAUGE SENDER MOUNTED
ON FUEL PUMP MODULE
Refer to FUEL SYSTEM for fuel pump testing. For
fuel level sender, follow procedures below.
Disconnect fuel pump connector.
Measure resistance as per table.
FUEL LEVEL SENDER
CONNECTOR
MEASUREMENT
PIN
RESISTANCE @
20°C(68°F)
B
C See table below.
B
C
smr2005-060-008_a
The resistance of the sender must be in accor-
dance with fuel level (measured from under the
flange) as specified in the following charts.
GTI RFI Series
RESISTANCE
(
)
FLOAT HEIGHT
(bottom of float with
bottom of pump module)
4.8 + 2.2 228 ± 5.0
17.8 ± 2.2 186 ± 5.0
27.8 ± 2.2 164 ± 5.0
37.8 ± 2.2 139 ± 5.0
47.8 ± 2.2 114 ± 5.0
57.8 ± 2.4 86 ± 5.0
67.8 ± 2.8 57 ± 5.0
77.8 ± 3.6 36 ± 5.0
89.8 ± 3.6 16 ± 5.0
208 smr2005-060
To Next Page
Loading...
