SeaDoo 3D - Page 350

Section 11 HULL/BODY
Subsection 02 (3D SERIES)
F22K0IA
2
1
1. Lower cover
2. Remove screws
Unscrew DESS switch nut using the DESS switch
tool (P/N 529 034 600).
1
F18K0FA
TYPICAL
1. DESS switch nut
Pull plastic rivet no. 2 out.
F22K0GA
Position seat post in the receiver.
Using a plastic hammer, push moto seat axle no. 3
out while holding seat.
F22K0HA
Post
Partially peel seat cover to expose screw no. 4.
340 smr2005-069
www.SeaDooManuals.net