Multi-speed parameter group04
PARAMETER DESCRIPTION 136
Programmed operation mode
speed 8 operating time
Programmed operation mode
speed 1 Acc/Dec time
Programmed operation mode
speed 2 Acc/Dec time
Programmed operation mode
speed 3 Acc/Dec time
Programmed operation mode
speed 4 Acc/Dec time
Programmed operation mode
speed 5 Acc/Dec time
Programmed operation mode
speed 6 Acc/Dec time
Programmed operation mode
speed 7Acc/Dec time
Programmed operation mode
speed 8 Acc/Dec time
Programmed operation mode
Programmed operation mode
1. The calculation method of running time and acceleration/deceleration time for each speed is shown in the
following figure:
frequency
Run
forward
Run
reverse
04-35
(P.111)
04-36
(P.112)
04-37
(P.113)
04-38
(P.114)
pause
04-39
(P.115)
04-40
(P.116)
04-41
(P.117)
04-42
(P.118)
04-42
(P.118)
04-27
(P.101)
04-28
(P.102)
04-29
(P.103)
04-30
(P.104)
04-31
(P.105)
04-32
(P.106)
04-33
(P.107)
04-34
(P.108)
2. Setting method of operation direction: set in binary (8 bit), then convert into decimal and set in parameter
04-16. Wherein, 1 means forward rotation, 0 means reverse rotation, the highest bit is the direction of speed 8,
and the lowest bit is the direction of speed 1.
For example: if speed 1 is forward, speed 2 is reverse, speed 3 is reverse, speed 4 is forward, speed 5 is
reverse, speed 6 is forward, speed 7 is forward, and speed 8 is reverse, then the binary number is 01101001.
04-16(P.121)=0×2
7
+1×2
6
+1×2
5
+0×2
4
+1×2
3
+0×2
2
+0×2
1
+1×2
0
=105
3. When 04-16(P.121) is set to 0, there will be no cycle operation.
4. When 04-17(P.122) is 1~8, it is the section that will cycle to after the first cycle.