Shihlin electric SE3 Series User Manual

System parameter group00
PARAMETER DESCRIPTION 75
5.1.14 Parameter mode setting
 Select “Sequence P mode” or “group mode” to display parameters.
Parameter
Name
Default
Setting Range
Content
00-25
P.990
Parameter display
mode setting
0
0
Parameter is displayed in “group mode”
1
Parameter is displayed in “sequence P mode”
Parameter mode setting
 “Group mode” displaying
V
A
Hz
PLC
RUN
MON
PU
52-00
 “Sequence P mode” displaying
V
A
HzPLC
RUN
MON
PU
0P
.
5.1.15 Frequency mode setting
Parameter
Name
Default
Setting Range
Content
00-27
P.991
Frequency mode
setting
0
0-1
0:Normal mode
1:High speed mode
Frequency mode setting
 After setting frequency mode setting 00-27 (P. 991), please be sure to set all parameters to default (p. 998, p. 997)
to fit the frequency-dependent parameters;
 Normal mode frequency related parameters range 0 ~ 650.00 HZ, minimum set unit 0.01 HZ;
 High speed related parameters range 0 ~ 1500.0 HZ, minimum set unit 0.1 HZ;
 Frequency related parameters refers to parameters with "Hz" as unit, For example, 01-00(P.1)~01-03(P.3)
04-00~04-02(P.4~P.6)
5.1.16 Expansion card type display
 This parameter is used to check the expansion card type, and cannot be modified.
Parameter
Name
Default
Setting Range
Content
00-26
P.125
Expansion card type
Read
Read only
It is used to display the current expansion card type, for read
only.
Current expansion card type

All bits are 1 when no card insert.
 The definition of each 00-26 (P.125) bit is as follows:
bit
2
0
2
1
2
2
2
3
bit
1
bit
0
bit
3
bit
2
Read
Setting
Display

Shihlin electric SE3 Series Specifications

General

Brand	Shihlin electric
Model	SE3 Series
Category	Inverter
Language	English