EasyManua.ls Logo

Siemens 6MD86 - Page 1134

Siemens 6MD86
1256 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Y values of the dropout characteristic
curve
0.00 s to 999.00 s Increments of 0.01 s
Dropout Ratio for Stage Type with User-Defined Characteristic Curve (Inverse Time)
Disk emulation Approx. 0.90 * threshold value
Time multiplier Approx. 1.05 * threshold value
Approx. 0.95 * pickup value
Tripping and Dropout Characteristic Curves
You can select from the following tripping and dropout characteristic curves:
Table 11-3 Standard characteristic curves to IEC
Normal inverse: type A See chapter 11.8.2 Stage with Inverse-Time Charac-
teristic Curve, Figure 11-1
Very inverse: type B
Extremely inverse: type C See chapter 11.8.2 Stage with Inverse-Time Charac-
teristic Curve, Figure 11-2
Long time inverse:
Table 11-4 Standard characteristic curves to ANSI/IEEE
Inverse: type C See chapter 11.8.2 Stage with Inverse-Time Charac-
teristic Curve, Figure 11-3
Short inverse
Long inverse See chapter 11.8.2 Stage with Inverse-Time Charac-
teristic Curve, Figure 11-4
Moderately inverse
Very inverse See chapter 11.8.2 Stage with Inverse-Time Charac-
teristic Curve, Figure 11-5
Extremely inverse
Definite inverse See chapter 11.8.2 Stage with Inverse-Time Charac-
teristic Curve, Figure 11-6
Direction Determination
Type
With externally generated voltages
With voltage memory 2 s
Forward range
V
ref,rot
±88
o
Dropout differential forward/reverse range
1
o
Directional sensitivity Unlimited for 1 and 2-phase short circuits
Dynamically unlimited, stationary for 3-phase short
circuits
Approx. 13 V phase-to-phase
Dropout
The greater dropout difference (= | pickup value – dropout value |) of the following 2 criteria
applies:
Dropout difference derived from the parameter
Dropout ratio
If this parameter is not available, a dropout ratio of 95 % applies for overcurrent and of 105 % for undercur-
rent functionality.
Minimum absolute dropout difference
Protection-class current transformer 15 mA sec. (I
rated
= 1 A) or
75 mA sec. (I
rated
= 5 A)
Technical Data
11.10 Directional Time-Overcurrent Protection, Phases
1134 SIPROTEC 5, High-Voltage Bay Controller, Manual
C53000-G5040-C015-9, Edition 11.2017

Table of Contents

Other manuals for Siemens 6MD86

Related product manuals