EasyManua.ls Logo

Siemens 6MD86 - Ordering Accessories

Siemens 6MD86
1256 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Ordering Accessories
i
i
NOTE
To order terminals, terminal accessories, and mechanical accessories in the order configurator, use the
Single part link.
Table A-1 Accessories
Group Accessories
Terminal Voltage terminal, terminal block, 14-pole
Terminal Voltage input (power supply)
Terminal block, 2-pole
96
Terminal Type A current terminal, 4 x protection
(for modular devices)
Terminal Type A current terminal, 3 x protection and 1 x measurement
(for modular devices)
Terminal Type A current terminal, 4 x measurement
(for modular devices)
Terminal Type B current terminal, 4 x protection
(for non-modular devices)
Terminal Type B current terminal, 3 x protection and 1 x measurement
(for non-modular devices)
Terminal 2-pole cross connector for current terminal
Terminal
Terminal pair printed circuit board assembly IO110
96
Terminal
Terminals and shielding for IO111
97
,
98
Terminal
Terminal kit for IO230/231
96
Terminal 2-pole cross connector for voltage terminal
Terminal Cover for current terminal block
Terminal Cover for voltage terminal block
Terminal Cover for empty plug-in module positions
Terminal Transport safety, current terminal
Terminal Transport safety, voltage terminal
Accessories USB covers (10 pieces each for CP 100, 200, 300)
Accessories Cable, integrated operation panel, 0.43 m
Accessories Cable, detached operation panel, 2.50 m
Accessories Cable, detached operation panel, 5.00 m
Accessories Cable set, COM link cable
Accessories Cover plate for plug-in modules
Accessories Set of angle rails
Accessories 10 x labeling strip, LEDs/function keys
Accessories 5 x labeling strips, push-buttons
Accessories Set of parts, mounting bracket 1/2
Accessories Set of parts, mounting bracket 2/3
Accessories Set of parts, mounting bracket 5/6
Accessories Set of parts, mounting bracket 1/1
A.2
96
Recommended tightening torque for fixing the terminal at the rear side: 0.3 Nm
97
The set consists of terminals and shielding for the IO111 for the terminal positions of M and N.
98
Only for non-modular devices 7xx82
Appendix
A.2 Ordering Accessories
SIPROTEC 5, High-Voltage Bay Controller, Manual 1207
C53000-G5040-C015-9, Edition 11.2017

Table of Contents

Other manuals for Siemens 6MD86

Related product manuals