[scauser7-220114-01-DE, 1, en_US]
Figure 5-86 Setting the Port, Channel Number, and Slave Address
Finally, load the configuration in the device.
Integration of an RTD-Unit Ethernet (TR1200 IP)
Device Configuration
In the DIGSI, insert an Ethernet module into the provided slot, thus, adding the module to the device configu-
ration. Figure 5-87 displays the available slots in the base module or on the expansion module CB 202. Alter-
natively, you can also use the integrated Ethernet interface Port J.
[scautcp1-220114-01-DE, 1, en_US]
Figure 5-87 Inserting an Ethernet Module
Communication Settings
Activate the SUP Ethernet protocol for the Ethernet module.
5.7.9.2
Function-Group Types
5.7 Function-Group Type Analog Units
SIPROTEC 5, High-Voltage Bay Controller, Manual 289
C53000-G5040-C015-9, Edition 11.2017
To Next Page
Loading...
