NOTE
•
The logged indications are preconfigured and cannot be changed!
•
This log, which is organized as a ring buffer. cannot be deleted by the user!
•
If you want to archive security-relevant information without loss of information, you must regularly
read this log.
Device-Diagnosis Log
Concrete take-action instructions are logged and displayed in the device-diagnosis log for the following items:
•
Required maintenance (for example, battery supervision)
•
Identified hardware defects
•
Compatibility problems
Up to 500 indications can be stored in the device-diagnosis log. In normal operation of the device, it is suffi-
cient for diagnostic purposes to follow the entries of the operational log. This specific significance is assumed
by the device-diagnosis log when the device is no longer ready for operation due to hardware defect or
compatibility problems and the fallback system is active.
Reading from the PC with DIGSI 5 in Normal Operation
•
To reach the device-diagnosis log of your SIPROTEC 5 device, use the project-tree window.
Project → Online access → Device → Device information → Logs tab → Device-diagnosis log
The status of the device-diagnosis log last loaded from the device is shown to you.
•
Before this, refresh the contents by clicking the update arrows in the headline.
[scdevdia-180816-01, 1, en_US]
Figure 3-16 Reading the Device-Diagnosis Log with DIGSI 5
Reading on the Device through the On-Site Operation Panel in Normal Operation
•
To reach the diagnosis log from the main menu, use the navigation keys of the on-site operation panel.
Main Menu → Test & Diagnosis → Logs → Device diagnosis
•
You can navigate within the displayed indication list using the navigation keys (up/down) on the on-site
operation panel.
3.1.5.8
System Functions
3.1 Indications
64 SIPROTEC 5, High-Voltage Bay Controller, Manual
C53000-G5040-C015-9, Edition 11.2017
To Next Page
Loading...
