Indications in DIGSI 5 Information Device Display Information
Log for parameter changes Time stamp (date and time),
Relative time,
Entry number,
Function structure,
Name,
Value,
Quality,
Cause,
Number
Time stamp (date and time),
Function structure,
Name,
Value
Spontaneous indication window
(DIGSI 5)
Time stamp (date and time),
Relative time
Indication,
Value,
Quality,
Additional Information
Time stamp (date and time),
Fault number,
Value
Log for safety indications
1
Time stamp (date and time),
Indication number,
Indication
Time stamp (date and time),
Indication
Log for device-diagnostic indica-
tions
2
Time stamp (date and time),
Indication number,
Indication
Time stamp (date and time),
Indication
Log for communication indications
3
Time stamp (date and time),
Indication number,
Indication
Time stamp (date and time),
Indication
Overview of Displayed Quality Attributes
If values are shown on the device display or in DIGSI, the following quality attributes are different for meas-
ured values and metered values.
Table 3-2
Measured Values
IEC 61850 Device Display/
DIGSI
Description
Detail Quality Validity
Good Invalid Questionable
- X Value The measured value is valid.
Failure X Fault The device is defective. Contact
Support.
Inaccurate X --- The measured value was not
calculated (for example, the
angle between current and
voltage if one of the 2 variables is
missing).
Bad Reference X ≈ Value The measured value can be inac-
curate (for example, outside the
frequency-tracking range).
Out of Range X > Value The measured value exceeds the
measuring range.
1
Only online access
2
Only online access
3
Only online access
System Functions
3.1 Indications
52 SIPROTEC 5, High-Voltage Bay Controller, Manual
C53000-G5040-C015-9, Edition 11.2017
To Next Page
Loading...
