Siemens HiPath 1120 - Page 213

Service Manual
6-213
Configuring the system specifically for the client
Table of the System’s Programming Codes
Cascade Call
Forwarding part-
ner
181 0 - Last
1 - First
automatic 0 - Last
Time in UCD
Queue
031 UCD Subscriber Group (00 to 99) in 5-second
cycles
# instead of
group
12 (1 minute)
On Hold Message
before Signaling
UCD Call
032 UCD Subscriber Group
∗ - to enable
# - to disable
# instead of
group
# - to disable
Minimum time for
UCD Queue On
Hold message
033 UCD Subscriber group (00 to 99) in 5-second
cycles
# instead of
group
00 (0
seconds)
Hunt Groups (HG) 021 Hunt Group (HG) extension or
∗ - to delete
# instead of
group
None
Call forwarding
within a Hunt
Group (HG)
223
∗ - to enable
# - to disable
Automatic # - to disable
Hunt Group selec-
tion (HG)
022 Hunt Group (HG) 1 - Linear
2 - Round-robin
# instead of
group
1- Linear
Timeout within a
Hunt Group (HG)
242 Hunt Group (HG) (01 to 24) in 5-second
cycles
Automatic 04
Override 144 extension 0 - Without permission
1 - With permission and
beep
# instead of
extension
0
Silent Monitoring 046 extension
∗ - to enable
# - to disable
# instead of
extension
# - to disable
Call Identification
for analog exten-
sion (CLIP)
010 Analog extension 0 - No Caller ID
1 - DTMF before ringing
2 - DTMF during ringing
3 - FSK before ringing
4 - FSK during ringing
5 = FSK prior to ringing or
during a conversation
6 = FSK during ringing or a
conversation
# instead of
extension
0 - Other
countries
3 - Korea
5 - France FT
Hide group prefix 188 extension
∗ - to enable
# - to disable
# instead of
extension
# - to disable
Electronic Lock
Password
126 extension 00000 to 99999
or
* - reset
Automatic 00000
Timeout Call
Forwarding - No
Answer
130 (01 to 99) in 5-second
cycles
Automatic 06 (30
seconds)
Dialing Mode 168 Extension Detection:
0 - Automatic
1 - Pulse (DP)
2 - Tone (DTMF)
# instead of
extension
0 - Automatic
Programmed
Functions
Code Intermediate data Data to be
programmed
Completing
data entry
Default