Siemens HiPath 1120 - Page 215

Service Manual
6-215
Configuring the system specifically for the client
Table of the System’s Programming Codes
Auto-Answering
Mode
034 extension ∗ - to enable
# - to disable
# instead of
extension
# - to disable
Pulses for call
charges on an
analog extension
041 Analog extension
∗ - to enable
# - to disable
# instead of
extension
# - to disable
Timer for outgoing
external calls
047 extension Call duration: 00000 to
17280 in 5-second cycles
# instead of
extension
36
Activate/Deacti-
vate timer for
outgoing external
calls
048 extension
∗ - to enable
# - to disable
Automatic # - to disable
Activate/Deacti-
vate timeout for
external calls
239 extension
∗ - to enable
# - to disable
Automatic # - to disable
Timeout for exter-
nal calls
240 extension Timeout for external calls
00000 to 64800 in 5-
second cycles
# instead of
extension
00000
Day to begin time-
out
241 (01 a 31) or
* To deactivate
Automatic * - deacti-
vated
Answering timeout
for a Second Atten-
dant for calls
received over MSN
082 Index: 001 to 140 (01 to 20) in 5-second
cycles
Automatic 06 (30
seconds)
Modem extension 085 Extension Automatic None
MSN and exten-
sion assignment
for external outgo-
ing calls
086 extension
+
1 - Day
2 - Night
Index: 001 to 140 Automatic None
External-to-exter-
nal transfer
091 extension
∗ - To activate
# - To deactivate
# instead of
extension
# - To deacti-
vate
Transfer when
extension is busy
217
∗ - To activate
# - To deactivate
Automatic ∗ - To acti-
vate
Elapsed timeout
for external-to-
external connec-
tion
218
∗ - To activate
# - To deactivate
Automatic # - To deacti-
vate
Configuring a time-
out for an external-
to-external connec-
tion
219 0000 to 1440 (in 1-minute
increments)
Automatic 1 hour
Disconnect time-
out after an exter-
nal-to-external
transfer
183 (004 to 120) in 5-second
cycles
Automatic 60 (300
seconds)
Programmed
Functions
Code Intermediate data Data to be
programmed
Completing
data entry
Default