01/02
2-9
8825/8830 Printer
LL-60/LL-61 NVM Fault RAP
Status Indicator RAPs
LL-60/LL-61 NVM Fault RAP
This RAP is used for NVM (Non-Volatile Memory) problems that are indicated by a status code
or a message display. The control panel displays the message NVM Fault Call For Assistance.
LL-60 or LL-61 may also be displayed. The problem may be caused when the NVM data are
corrupted or partially corrupted. The contents of the NVM do not agree with the checksum, or
the contents of the NVM do not agree with the shadow contents.
LL-60 - This status code indicates corrupted data in NVM. Perform steps 1 through 4 of the
procedure.
LL-61 - This status code is an indication that an older version of firmware has been installed.
Ensure that the newest version of firmware is installed. If the problem persists, perform steps 1
through 4 of the procedure.
Procedure
The purpose of this procedure is to restore the printer to normal operation condition. Go to To
Enter The Diagnostic Mode located in Section 6 when performing this procedure.
1. Enter the following diagnostic codes and record the corresponding data values displayed
on the control panel:
2. Enter [0360-1] for NACO printers or [0360-3] for EO printers to reset the contents of the
NVM to the factory default values.
3. Enter [0921-6] and then compare the values recorded in step 1 to previously recorded
values for this printer. Enter the codes listed in step 1 and change the default values as
required.
NOTE: If any value recorded in step 1 appears to be incorrect, use the previously recorded
value. If there is no previously recorded value, retain the default value.
4. Check/adjust the following:
NOTE: If the values entered are not retained, replace the NVM (PL 1.1A) and perform steps 2-
4 again.
Table 1
[02-61] Country Configuration
[0360-2] Electronic Billing Meters value
[0760] Delay Between Film Prints
[0860] Lead Edge Registration value
[0862] Cut length value
[0903] Image Module Output Light Value
[0921-2] Vhigh
[0921-3] Illumination (Exposure) value
[1034] Remaining Oiler Web Life
[1060] Fuser Temperature
[1062] Fuser Temperature
[1063] Fuser Temperature
Table 2
ADJ 8.1 Vertical Magnification
ADJ 8.2 Lead Edge Registration
ADJ 8.3 Cut Length
ADJ 9.2 Electrostatic Series
ADJ 10.1 Fuser Temperature
Table 2
To Next Page
Loading...
Need help?
General