01/02
4-41
8825/8830 Printer
REP 8.17
Repairs and Adjustments
REP 8.17 Registration Drive Roll
Parts List on PL 8.2
WARNING
Switch off the Main Power Switch. Disconnect the Power Cord.
Removal
1. Latch the Xerographic Module at the Service Position (REP 9.2).
2. Remove the Media Transport Assembly (REP 8.1).
3. Remove the Fabric Guide (REP 8.9).
4. Remove the Pressure Plates (REP 8.5).
5. Turn the Media Transport Assembly over.
6. (Figure 1): Remove the Media Feed Drive Belt.
7. Turn the Media Transport over and remove the screws (2 each side) and the baffle that
they secure.
Figure 1 Removing the Media Feed Drive Belt
Idler Pulley
1
Disconnect the connector
2
Remove the screws (3)
4
Remove the Media
Feed Drive Belt
3
Remove the motor
Assembly
To Next Page
Loading...
