01/02
4-39
8825/8830 Printer
REP 8.15
Repairs and Adjustments
REP 8.15 Cutter Home Sensor
Parts List on PL 7.8
WARNING
Switch off the Main Power Switch. Disconnect the Power Cord.
NOTE: The art used for this procedure was developed for previous products and may not
match the 8825/8830 configuration exactly.
Removal
1. Open the Cutter Drawer.
2. (Figure 1): Remove the Cutter Home Sensor.
Figure 1 Removing the Cutter Home Sensor
Replacement
1. Center the Disc of the Cutter Drive Pulley in the sensor during reassembly.
2
Squeeze the tabs
1
Disconnect the connector
Cutter
Drive
Pulley
3
Rotate the sensor
and remove it
To Next Page
Loading...
