01/02
2-17
8825/8830 Printer
Generic Clutch RAP
Status Indicator RAPs
Generic Clutch RAP
Initial Actions
NOTE: This procedure can be used to check any clutch. Due to the generic format of this RAP
there will be no specific ADJ, PL or Diagnostic codes identified.
Procedure
( Figure 1): Enter DIAGNOSTICS (General Procedures). Enter code [xxxx to test the Clutch
(Refer to appropriate BSD for the specific code). Actuate the Clutch. The Clutch energizes.
YN
Deactuate the clutch. There is +26 VDC at J209-12 (use the actual connector/pin
number on the BSD) on the Driver PWB (A2).
YN
Check the wire for an open circuit. If the wires are good, replace the Clutch (PL X.X).
Actuate the Clutch. The voltage decreased to approximately 0 VDC.
YN
Replace the Main PWB (PL X.X).
Check the adjustment of the Clutch (ADJ X.X). If the adjustment is good, replace the
Clutch (PL X.X).
The Clutch and its circuit appear to be operating normally. Check the adjustment or alignment
of the Clutch.
Figure 1 Clutch (Generic)
To Next Page
Loading...
Need help?
General