Xerox 8825 Service Manual

01/02
4-97
8825/8830 Printer
ADJ 3.2, ADJ 8.1
Repairs and Adjustments
ADJ 3.2 Country Configuration
Purpose
WARNING
The purpose is to set the Line Service (Input Power) and Billing Type (Billing Meter) con-
figurations according to the customer’s requirements.
Adjustment
1. Enter diagnostics.
2. Enter code [ 0261].
3. Table 1: Set the Line Service configuration using the Previous / Next buttons.
a. Use the Next button to increase the Adj setting.
b. Use the Previous button to decrease the Adj setting.
c. Press the Enter button in order to store the value in NVM.
d. Press the Exit button.
4. Enter code [ 0263].
5. Table 2: Set the Billing Type configuration using the Previous / Next buttons.
a. Use the Next button to increase the Adj setting.
b. Use the Previous button to decrease the Adj setting.
c. Press the Enter button in order to store the value in NVM.
d. Press the Exit button two times.
6. Exit the diagnostics mode.
ADJ 8.1 Vertical Magnification
Purpose
WARNING
The purpose is to calibrate the printer to produce the correct length images for each
media type.
Prerequisite
1. Check the Fuser Temperature (NVM) ( ADJ 10.1).
Check
1. Enter diagnostics.
2. Enter code [ 0955] and make one 1200 mm print of Test Pattern #7.
3. Allow the print to cool for five minutes.
4. (Figure 1): Check that 60 blocks in the paper feed direction measure 975 mm +/- .80 mm.
Figure 1 Checking the Vertical Magnification
Adjustment
1. Enter code [ 0602] in order to adjust the Vertical Magnification.
2. Figure 2 Select the type of media. The following message is displayed. (In this example,
bond paper media has been selected.)
Table 1 Line Service
Adj Configuration
00 115V
01 240V
02 220V
Table 2 Billing Type
Adj Configuration
00 FEET
01 METRIC

Xerox 8825 Specifications

General

Brand	Xerox
Model	8825
Category	Printer
Language	English